The CMT 330 is a three-sided trimmer designed for the on-demand printing environment. It features full digital control of the trimming process - servomotors control all adjustments normally done by hand with a traditional trimmer. Just key in the starting size and the finish size, and the trimmer takes it from there. The control panel features a graphic LCD display of the job being trimmed. For repeat jobs, the CMT 300 can store 99 book trimming jobs in its memory. It can be used in line with perfect binders, or used off-line in a manual feed mode.

• Graphic LCD User Interface
• Eight-Station Cooling Tower for in-line systems allows ample set-up time before books are trimmed.
• Serial Communication Port permits remote setup and control for fully automated bookshop environments.
• For added safety while changing blades, a custom-designed edge guard shields the knife. Blades are easily accessible for Fast, Efficient Changes.
• Infrared Sensor monitor each waste bin and generate a display on the control panel when a bin is full.
• Included: Cut Stick, Cut Stick Puller, Knife Lifter, Three Waste Bins, Three Knives, Two Cut Plates, Eighteen Knife Bolts and a T-Handle Hex Wrench.

• Minimum Book Size" 4" x 6" (101.5 x 152.4 mm)
• Maximum Book Size: 9.5" x 12.5" (241 x 317.5 mm)
• Maximum Book Thickness: 2" (50.8 mm)
• Minimum Trim: 0.125: (3.2 mm)
• Maximum Face Trim: 5.5" (140 mm)
• Speed: 400+ Books Per Hour
• Memory: 99 Book Jobs
• Set-up Time for Book Size Changes: 15 seconds

• Overall Height;: 61" (1549 mm)
• Overall Width: 34.5" (876 mm)
• Overall Length: 84" (2134 mm)
• Net Weight (approximate) 2 500 lbs (876 kg)
• Shipping Weight (approximate): 2800 lbs (2134 kg)

• Three Phase, 60 Hz, AC  
• 1208/230 Volts, 25 Amps (service size 40 Amps)
• Air Supply Requirements: 90 PSI, 5 CFM Unlubricated
• UL Listed

[ Home ] [ Up ] [ Challenge Round Corner Machine ] [ Challenge CMT-300 Three-Kinfe Trimmer ]